IBM eServer 200 xSeries User Reference Manual page 88

Code Function
202 System cache
206 Diskette drive
215 CD-ROM
217 Hard disk drive
74
IBM xSeries 200: User's Reference
Result
Aborted Test setup error: BIOS cannot access VPD
information
Test setup error: Corrupt DMI BIOS, information in
BIOS is not as expected
Test setup error: No L2 cache detected on
microprocessor socket id xyz or BIOS setup
problem
(where xyz identifies the microprocessor that is
causing the error message)
Test setup error: Unknown hardware problem
associated with microprocessor in socket id xyz.
(where xyz identifies the microprocessor that is
causing the error message)
Failed Microprocessor in socket ID xyz
(where xyz identifies the microprocessor that is
causing the error message)
Warning Test setup error: Cache is disabled. Use system
setup to enable before retrying the test
Failed Internal diskette drive bay
Failed On system board.
Aborted The CD-ROM drive is not present.
Failed BIOS drive # n (where n is the drive bay number)
Text message Action
If your system does not
have the latest level
BIOS code installed,
update the BIOS code to
the latest level and run
the diagnostic program
again.
If the problem persists,
call for service.
1. If your system does
not have the latest
level BIOS code
installed, update
the BIOS code to
the latest level
2. Run the diagnostic
program again.
3. If the problem
remains, replace
the failing
processor.
If the problem persists,
call for service.
1. Reseat the
identified
microprocessor.
2. If the problem
remains, replace
the microprocessor.
If the problem persists,
call for service.
Use the Cache Control
choice under the
Advanced Setup menu,
under the
Configuration/Setup
Utility program main
menu, to enable the
cache.
If the problem persists,
call for service.
Call for service.
Call for service.
Verify that the cables are
properly connected to
the CD-ROM drive. If the
problem persists, call for
service.
Call for service.