Table of Contents
Advertisement
Installing a security rope clip
To help prevent hardware theft, you can add a security rope clip and cable to your
server. After you add the security cable, make sure that it does not interfere with
other cables that are connected to the server.
Before you begin, obtain the following items:
v A flat-blade screwdriver
v An adjustable wrench
v A 19 mm (0.75 in.) rope clip or wire rope (similar to National Manufacturing
v Threaded nuts that fit the rope clip
v A security cable
v A lock, such as a combination lock or padlock
Complete the following steps to install a rope clip:
1. Turn off the server and all attached devices. Disconnect all external cables and
2. Use a screwdriver to remove the two metal knockouts.
3. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
4. Thread the cable through the rope clip and around an object that is not part of
5. If you have other options to install or remove, do so now; otherwise, go to
number 3230, stock number 176-735)
power cords; then, remove the side cover. See "Removing the side cover" on
page 15.
or permanently secured to the building structure or foundation, and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, make sure that it does not interfere with other
cables that are connected to the server.
Rope clip
"Completing the installation" on page 38.
Chapter 2. Installing options
37
Advertisement
Table of Contents
