Setup And Configuration Overview - IBM eServer 200 xSeries User Reference Manual

Setup and configuration overview

When you use the Setup and Installation CD, you do not need setup diskettes. You
can use the CD to configure any supported IBM server model. The setup program
checks your system BIOS, service processors, and other system hardware to
determine if system updates are available. The setup program provides a list of tasks
that are required to set up your server model. On RAID servers, you can run the
ServeRAID Manager program to create logical drives.
Note: Exact features and functions can vary with different versions of the
When you start the Setup and Installation CD, the following happens:
•
•
•
•
Notes:
1. Plug and Play adapters are configured automatically. Non-Plug and Play adapters
2. Diagnostics for your server come in BIOS code or on a separate diagnostics CD.
ServerGuide software.
You are prompted for your language, country, and keyboard layout. (This
information is stored and later passed on to the NOS installation program.)
The ServerGuide program displays choices for running the configuration
programs. For example:
— The Express Configuration method runs the required programs for your
server, based on the hardware that is detected.
— The Custom Configuration method displays all programs that are available for
your server, and you decide which programs to run.
— The Replicated Configuration method provides the option of duplicating your
setup selections to other servers that are the same model.
If you select the Custom Configuration method, the following programs are
optional. If you select the Express Configuration method, some or all of these
programs are run, depending on the hardware that is detected.
— The Set Date and Time feature is provided so that you do not have to use the
Configuration/Setup Utility program to access these settings.
— The Clear Hard Disks program is provided so you can delete all partitions on
all hard disk drives. If the server has a ServeRAID adapter installed, you can
select to restore the configuration on the ServeRAID adapter to the factory
default settings.
— The ServerGuide program checks the server BIOS code and microcode
(firmware) levels for supported options and then checks the CD for a newer
level. CD content can be newer than the hardware. The ServerGuide program
can perform a flash update of the BIOS code and supported microcode
(firmware) options without the use of diskettes.
— The ServeRAID program starts, leading you through the entire configuration
process.
— The Performance Optimizer program easily tunes your server for your
environment.
— The ServerGuide program creates a System Partition on the default drive.
The ServerGuide program displays a confirmation summary, so that you will know
when you have completed all the required tasks. Then, you are ready to install
your NOS.
or non-IBM adapters might require switch settings, additional device drivers, and
installation after the NOS is installed. See the documentation that comes with the
adapter.
Chapter 4. Using the ServerGuide CDs
19