Copying
Copying from Paper Tray 2
You can use Paper Tray 2 as an alternative Bypass Tray to copy non-standard pa-
per. You can also use Paper Tray 2 as an ordinary tray.
Important
❒ Paper has a vertical length of 100-297 mm (3.94-11.69 inch) and a horizontal
2
length of 148-432 mm (5.83-17 inch) can be copied from Paper Tray 2.
❒ For sizes, types, and thicknesses of paper you can use, or the maximum number
of sheets you can load at once, see "Copy Paper", About This Machine.
❒ When copying onto special paper such as OHP transparencies, thick paper
postcards, envelopes, etc.), thin paper, and adhesive label paper, you must
specify the paper type. See "When copying onto special paper".
❒ To load paper, see "Loading Paper into Paper Trays", Troubleshooting.
Reference
p.29 "When copying onto special paper"
"Copy Paper", About This Machine
"Loading Paper into Paper Trays", Troubleshooting
Using Tray 2 as the Bypass Tray
This section explains how to use Paper Tray 2 as the Bypass Tray.
Important
❒ Paper size and type settings programmed by pressing the {q} key are
cleared and reset automatically when copying is completed.
❒ If the paper size shown on the key for tray 2 is different that of the paper set
in tray 2, paper might misfeed. Be sure to remove any paper left in the tray
after copying.
26