Interrupt Copy - Ricoh MP 2510 Manual

Copying
F
Press the {Start} key.
The machine starts copying.
When placing originals on the exposure glass, press the {q} key after all
originals are scanned.
Copies are delivered face down.
Note
2
❒ Always log off when you have finished using the machine to prevent un-
authorized users from using the machine.
❒ To stop the machine during a multi-copy run, press the {Clear/Stop} key.
❒ To return the machine to its initial state after copying, press the {Clear
Modes} key.
❒ To clear entered values, press the {Clear/Stop} key or [Cancel] on the screen.
❒ To confirm settings, press the {Check Modes} key.
Reference
"When the Authentication Screen is Displayed", About This Machine
"Administrator Tools", General Settings Guide

Interrupt Copy

Use this function to interrupt a long copy job to make urgently needed copies.
Important
❒ You cannot use Interrupt Copy with the scanner function, or when fax origi-
nals are being scanned.
A
Press the {Interrupt} key.
B
The machine stops scanning. Remove the originals that were being copied.
C
Place the originals you want to copy.
D
Press the {Start} key.
The machine starts making copies.
E
When copying is complete, remove the originals and copies.
F
Press the {Interrupt} key again.
The interrupt key indicator goes off.
G
Replace the originals that you were copying, and then press the {Start} key.
Following the instructions on the display, replace the originals that you were copying.
Note
❒ The previous copy job settings are restored. Simply press the {Start} key to
continue copying from where it left off.
24