Temporarily Stopping One Job To Copy Something Else (Interrupt) - Ricoh FT9105 Operating Instructions Manual

TEMPORARILY STOPPING ONE JOB TO COPY SOMETHING ELSE (INTERRUPT)

TEMPORARILY STOPPING ONE JOB TO COPY
You can interrupt a multi-copy run to make urgently needed copies.
While in Interrupt mode, you cannot use Duplex, Finishing, or Cover/Paper Desig-
nate and you cannot set originals in the recirculating document handler.
.
1
Press the Interrupt key during
the copy run.
If you press the Interrupt key when
setting a stack of originals in the re-
circulating document handler, inter-
rupt will be possible after the current
cycle of original feeding has finished.
If you press the Interrupt key while
setting originals in the document
feeder or setting an original on the
exposure glass, the copy run will
stop immediately and interrupt will be
possible.
.
2
Remove the current originals from the exposure glass or the document
feeder and set the interrupt originals. Then, make the interrupt copies.
You do not have to remove originals from the recirculating document handler.
.
3
After the interrupt copying is completed, press the Interrupt key again.
The copier will recall the previous copy settings.
100
SOMETHING ELSE (INTERRUPT)
Energy Saver
Interrupt
Clear Modes
C