Download Table of Contents Print this page

Venting Requirements - Kenmore Sensor Smart Use And Care Manual

Advertisement

Table of Contents
Direct Wire or Power Supply Cord
Where local codes do not permit connecting cabinet-
ground conductor to neutral wire.
1. Remove center terminal block screw.
2. Remove appliance ground wire (green with yellow stripes)
from external ground connector screw. Connect appliance
ground wire and the neutral wire (white or center wire) of
power supply cord/cable under center, silver colored terminal
block screw. Tighten screw.
3. Connect the other wires to outer terminal block screws.
Tighten screws.
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
6. Connect a separate copper ground wire from the external
ground connector screw to an adequate ground.
1
1. External ground connector
2. Neutral grounding wire (green/yellow)
3. Neutral wire (white)
4. Grounding path determined by a
quailied electrician

Venting Requirements

Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in
death or fire.
WARNING:
EXHAUSTED OUTDOORS.
2
4 in. (10.2 cm) heavy metal exhaust vent and clamps must be
used. DURASAFE™ venting products are recommended and are
available from your local Sears store or Sears Service dealer.
3
DURASAFE vent products can be purchased from your dealer or
by calling 1-800-366-PART (1-800-366-7278).
Visit our internet site at: www.sears.com
4
Do not exhaust the dryer into any gas vent, chimney, wall,
ceiling, or a concealed space of a building.
The diameter of the heavy metal exhaust vent must be 4 in.
(10.2 cm).
Do not use an exhaust hood with a magnetic latch.
Do not install flexible metal vent in enclosed walls, ceilings or
floors.
Do not use screws or other fastening devices that extend into
the interior of the vent to secure vent.
IMPORTANT: Observe all governing codes and ordinances.
Improper venting can cause moisture and lint to collect
indoors, which may result in:
Moisture damage to woodwork, furniture, paint, wall-
paper, carpets, etc.
Housecleaning problems and health problems.
Use a heavy metal vent. Do not use plastic or metal foil vent.
Rigid metal vent is recommended to prevent crushing and
kinking.
Flexible metal vent must be fully extended and supported when
the dryer is in its final position. Remove excess flexible metal vent
to avoid sagging and kinking that may result in reduced air flow.
An exhaust hood should cap the vent to prevent rodents and
insects from entering the home.
Exhaust hood must be at least 12 in. (30.5 cm) from the ground or
any object that may be in the path of the exhaust (such as
flowers, rocks or bushes, etc.).
Fire Hazard
To reduce the risk of fire, this dryer MUST BE
11

Advertisement

Chapters

Table of Contents
loading

Related Manuals for Kenmore Sensor Smart

Table of Contents