Removing And Replacing The Server Access Cover; Removing The Access Cover - Toshiba Magnia 3135R User Manual

Connecting Hardware Devices

Removing and Replacing the Server Access Cover

This section provides instructions for removing and replacing the access cover on
Toshiba Magnia 3135R servers.

Removing the Access Cover

1 If the server is powered on, shut down the operating system.
2 Press and hold the Power button to power-down the server.
3 Disconnect the server from the AC power source.
4 Unplug the display cable, keyboard cable, and any other peripheral device cables
connected to the server.
5 Loosen the two thumbscrews securing the server to the rack.
6 Grasp the handles on both sides of the server and slowly pull the server from the
rack. Latches on both rack rails stop the server when it reaches its fully extended
position. Make sure the latches lock, preventing the server from sliding back.
7 Loosen the three thumb-screws on the rear of the system.
8 Pull the cover back and remove it from the chassis.
Removing cover thumb-screws on back of server

Removing and Replacing the Server Access Cover

53