Table of Contents
Advertisement
10
Run the BIOS Setup to verify the correct settings (see Chapter 3).
Password Jumper
The jumper at pins 3 and 4 controls whether the user and administrative passwords are
retained or cleared during a system reset.
Use the following procedure to clear the current password and then enter a new one:
1
See "General Procedure to Change Jumper Setting" above.
2
Short the Password jumper on 3 and 4.
3
Reinstall the cover for your safety and connect the power cord to the system.
4
Turn the system on and wait for POST to complete. This automatically clears the
password.
5
Turn off the system and disconnect the power cord.
6
Remove the cover.
7
Remove the jumper from pin 3 and 4.
8
Reinstall the cover and connect the power cord to the system.
FRB Timer Enable Jumper
The jumper at pins 1 and 2 controls the FRB timers.
Use the following procedure to disable the FRB timer:
1
See "General Procedure to Change Jumper Setting" above.
2
Remove the cover.
3
If the FRB Timer enable jumper is shorted on Pin 1 and 2, the FRB timer is disabled.
4
Reinstall the cover for your safety and connect the power cord to the system.
5
Turn the system on and wait for POST to complete.
Chassis Intrusion Detection Jumper
The chassis contains an alarm switch that sends a notification signal to the server
management software if a cover is removed.
Use the following procedure to connect the chassis:
1
See "General Procedure to Change Jumper Setting" above.
2
Remove the cover.
176
Advertisement
Table of Contents
