Ipv4 Address; Ipv4 Subnet Mask; Ipv4 Default Gateway; Ipv6 Subnet Prefix Length - Canon MX920 Series Online Manual

LAN settings

• Change wireless/wired
Activates either wireless LAN or wired LAN. You can also deactivate wireless/wired LAN.
• Wireless LAN setup
Selects the setup method for wireless LAN connection.
Note
You can also enter this setting menu by selecting WLAN setup from the menu screen.
When this menu is selected, the machine starts searching for a WPS-compatible access point. If the
machine detects the access point, follow the on-screen instructions to set up wireless LAN. If an
access point is not detected or if you select another setup method, select one of the setup methods
below.
• Standard setup
Select when you perform settings for wireless LAN manually using the operation panel of the
machine.
• WPS
Select when you perform settings for wireless LAN using Wi-Fi Protected Setup (WPS). Select
Push button method or PIN code method according to the method your access point supports,
then follow the on-screen instructions.
• Other setup
Select Advanced setup, then follow the on-screen instructions.
• Confirm LAN settings
The list of wireless/wired LAN settings of this machine is displayed on the LCD.
You can print the list from this setting menu.
• WLAN setting list
The list of wireless LAN settings of this machine is displayed on the LCD.
The following setting items are displayed.
Items
Connection
SSID
Communication mode
Channel
Wireless LAN security

IPv4 address

IPv4 subnet mask

IPv4 default gateway

IPv6 address

IPv6 subnet prefix length

IPv6 default gateway
MAC address
IPsec settings

Pre-shared key

Printer name

Bonjour service name

Active/Inactive
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
Infrastructure
XX
Inactive/WEP(64bit)/WEP(128bit)/WPA-PSK(TKIP)/WPA-
PSK(AES)/WPA2-PSK(TKIP)/WPA2-PSK(AES)
XXX. XXX. XXX. XXX
XXX. XXX. XXX. XXX
XXX. XXX. XXX. XXX
XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX
XXX
XXXX: XXXX: XXXX: XXXX:
XXXX: XXXX: XXXX: XXXX
XX:XX:XX:XX:XX:XX
Enable (ESP)/Enable (ESP & AH)/Enable (AH)/Inactive
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXX
XXXXXXXXXXXXX
XXXXXXXXXXXXX
Setting