Table of Contents
Advertisement
Symptom
OSD menu cannot be used.
"Aspect Marker", " Safety Zone Marker " or
"Area Marker" does not appear.
The fan starts to rotate even when "Fan"
under "Camera Link" is set to "On" or
"Fan Stop" is set to "On".
The fan does not stop even when "Fan"
under "Camera Link" is set to "On" or
"Fan Stop" is set to "On".
You forgot the password for "Protect
Settings".
The video display does not start up in the
condition that the power was turned off
last time.
86
Troubleshooting
• Check that "Protect Settings" is not set.
• A channel with no signal, unsupported signal, or with "Input
Configuration" not set may be selected. Check the signal.
• The fan stays off for approx. 1 minute when an AC power supply is used.
To keep the fan off for a longer period, use a DC power supply.
• When "Fan" under "Camera Link" is set to "On", the down time may not
match the camera.
• The fan does not stop if the internal temperature of the video display is
high. Configure settings after the internal temperature has lowered.
• The fan may not stop in some conditions, for example when used at a
high temperature. Use the video display at the operating temperature
(
66) or lower.
• Press the jog dial and the button while the video display is in standby.
The configuration will be reset to the state where no password is set.
• Check the "Power on Setting" on the OSD menu. Set "Last memory"
to start up the video display in the condition that the power is turned off
last time.
Cause and Action
63
65
59
63
59
63
9
64
Advertisement
Table of Contents
