Canon DP-V2410 Instruction Manual page 84

Hardware error Backlight error.
Fan error.
Panel error.
I/F error.
System error.
Invalid operation due to high temperature.
Input signal No Signal
Unsupported
"Input Configuration" is different from Payload.
Operation Invalid operation.
"Protect Settings" is on.
"CDL Bypass" is on.
Invalid Password.
USB memory USB memory is not connected.
Unsupported USB memory.
DC power supply Low Voltage.
Low Voltage, Turn off power.
Invalid Voltage, Turn off power.
84 Error Messages
Message Description and Action
Disconnect the power cord, reconnect it, and then
turn on the power.
If the message persists, contact Canon Customer
Center.
The temperature inside the main unit is high. Turn off
the power and wait until the fan stops.
Displayed when there is no video signal input.
Unsupported video signal is input. Check the
supported signal format (
Check the "Input Configuration" (
Information" ( 65) settings. Reset any incorrect
"Input Configuration" settings.
Operation is disabled. Check the setting items.
To use the OSD menu, move the selection frame
to "Protect Settings" and press the jog dial for
approximately 3 seconds.
When "CDL Bypass" is turned "On", you cannot
adjust "Power", "Saturation", "Offset", or "Slope".
Enter the correct password.
Correctly connect the USB memory to the USB port
of this main unit.
Check the USB memory format and make sure it is
not protected.
Indicates that the input voltage of the DC power
supply has become below approx. 22.5 V. Check the
voltage of the DC power supply.
Indicates that the input voltage of the DC power
supply has become below approx. 21.0 V and the
power will be turned off. Connect a 23.5 V or higher
DC power supply and press the button to turn on
the power.
Indicates that the input voltage of the DC power
supply has reached approx. 35.8 V or higher. Check
the input voltage of the DC power supply.
68).
43) and "Signal