Canon DP-V2410 Instruction Manual page 52

Item
Area Marker
Enable
H Position
V Position
Width (dot)
Height (dot)
Mask
Line
Line Width
Line Color
Line
Brightness
52 OSD Menu
Setting Options (underline indicates factory default)
"Area Marker" is used to check a specific area using a rectangular box.
Note
"Area Marker" is not displayed in the following cases:
• When there is no signal, unsupported signal, or a channel with "Input Configuration" not set is
selected
• When an enlarged image is displayed
• During the execution of "Playback File" under "Screen Capture"
• When a "Test Pattern" is displayed
Switches the area marker On, Off.
On, Off
Sets the start position (x-coordinate) to draw the rectangle (in increments of 2).
0 to 4086 (240)
Sets the start position (y-coordinate) to draw the rectangle (in increments of 2).
0 to 2150 (120)
Sets the width of the rectangle (in increments of 2).
10 to 4096 (240)
Sets the height of the rectangle (in increments of 2).
10 to 2160 (120)
Switches the mask color (in the marker).
Black, Half, Off
Turns On/Off the outlines of the rectangular box.
On, Off
Sets the width of the area marker line.
Thick, Normal, Thin
Sets the color of the area marker line.
White, Red, Green, Blue, Yellow, Cyan, Magenta
Sets the brightness of the area marker line.
High, Low