Assembly; Assembly & Hardware; Assembly 7.1 Assembly & Hardware - Matrix T3x Series Owner's Manual

7.0 A
SSEMBLY
7.1 ASSEMBLY & HARDWARE
• ATTENTION
After installation is completed, the treadmill will need to be calibrated by using the AUTO-CHECK
function. If this is not done, the treadmill's speed and incline values may be incorrect and damage the
treadmill. Do not stand on the belt when performing the AUTO-CHECK function.
• ASSEMBLY INSTRUCTIONS
To ensure correct assembly of the treadmill, carefully read and follow these steps:
Please make sure that the power plug is not plugged into the wall outlet while completing the following
procedure.
STEP 1
Remove the motor cover. Pull out the console cable and route it through the Right
console mast. Place the right console mast and then the left console mast in the
console post support brackets. Secure the Right and Left mast with the 4 bolts
provided (Z50, Z51). Make sure these bolts are tight.
Z51
Z50
Z50
Z51
REF #
Z01
Z02
Z03
Z50
Z51
Z52
Z53
STEP 2
Connect the console cables from the console set to the motor control board
cables. Secure the console set with 2 screws (Z52) on each side.
9
DESCRIPTION
Screw Driver
Wrench (M8)
Wrench (M10)
Washer (30x2.0t)
Screw, Socket Head (M10x25L)
Screw, Socket Head (M8x30L)
Screw, Socket Head (M5x12L)
Z52
Z52
QTY
1
1
1
8
8
4
2