FLIR SyncroIP Series Software Manual page 25

1. Check Enable to enable motion detection.
2. To configure a schedule when motion detection will be activated, click Setup next to Working
Period.
Configure up
to 6 time
periods
• Select the day you would like to configure by clicking the Setup buttons. You can apply the
same schedule to multiple days using the checkboxes.
• Configure up to 6 time periods when motion detection will be activated.
• Click Save. Repeat the steps above if you would like to apply a different schedule to different
days.
3. Under Anti-dither, enter the anti-dither time. After a motion event occurs and motion stops,
if motion is detected within the anti-dither time, the system continues the motion event and
includes the new motion within the first event, rather than creating a new motion event.
4. To configure the motion grid, click Setup next to Area.
• Areas where motion detection is enable are represented by yellow boxes.
• To resize an area, click on one of the corners and drag.
• To move an area, click inside and drag.
• Right-click to delete the selected area.
• Click and drag outside of all areas to draw a new area. You may have up to 4 motion areas.
• Use the sliders to adjust the Sensitivity and Threshold for motion detection.
• The Sensitivity determines how sensitive the camera is to motion. For example, if the
sensitivity is high, small amounts of motion will score higher on the graph. It is
recommended to select a Sensitivity between 30~70.
• The Threshold determines how much motion is required to trigger an alarm or recording.
It is represented by the horizontal line on the graph. If the amount of motion in the area
exceeds this line, it will trigger an alert. It is recommended to select a Threshold between
10~50.
• Each motion area can have a separate Sensitivity and Threshold value.
Web Configuration Interface
Click Setup to select the day
to configure
Click the checkboxes to
apply the same schedule to
multiple days
20