Profile Management - FLIR SyncroIP Series Software Manual

• Low Motion Blur: The system will automatically adjust the shutter to reduce motion
trails in the image. Set the minimum and maximum Shutter Scope.
• Manual: Configure manual exposure settings. Configure the Shutter Regulate and Gain
Scope.
• Profile: Select the white balance mode.
• Auto: Automatic white balance.
• Sunny: White balance mode for daylight.
• Night: White balance mode for night time.
• Customized: Manual white balance. Use the sliders to configure the Red Control and
Blue Control.
• Auto Iris (auto iris cameras only): Select ON to enable auto iris or OFF to disable auto iris.
• Day & Night: Select one of the following day / night modes.
• Color: Camera will be in day mode at all times.
• Auto: Camera will automatically change between day and night mode based on the
lighting.
• B/W: Camera will be in black and white at all times.
• BLC Mode: Select one of the following modes:
• BLC (Backlight Compensation): The camera automatically adjusts the exposure for a
clearer image in the darkest areas of the video. Click Default to use default settings or
Customized to adjust the BLC area. The darker the area you select, the brighter the
image will be.
• WDR (Wide Dynamic Range): The camera compensates for changes in brightness across
the image to enhance the picture quality of both light and dark areas. Adjust the WDR
level between 1 and 100.
• HLC (Highlight Compensation): The camera dims the brightest areas of the image to
make them clearer. Adjust the HLC level between 1 and 100.
• Off: Disable this function.
• Mirror: Select ON to flip the camera left and right.
• Flip: Select one of the options to flip the image or No Flip to disable. Note that 90° rotations
are not supported if the Main Stream is set above 720p resolution.
2. Click Save to save changes. Click Cancel to return to last saved configuration. Click Default
to return to factory defaults.

Profile Management

The Profile Management tab allows you to set which Condition Profile to use at what times.
To configure the condition profile:
1. Select one of the following options:
Web Configuration Interface
10