Latch Plate And Door Latch; Inner Door Glass - Electrolux EIGD55H Technical & Service Manual

Latch Plate and Door Latch Removal
The latch plate is secured with two long coarse thread
screws to the inner face of the door assembly. The door
latch is secured to the inside of the latch plate with a
screw and positioned on locating pins. The door latch
may be removed without removing the door assembly.
To remove the latch plate:
1. Using a #2 square bit screwdriver, remove the two
long, course thread, countersunk screws.
(See Figure 4-4)
2. Lift latch plate from door assembly.
3. Using a #2 Phillips head screwdriver from the
underside of the latch plate, extract the screw while
compressing the spring assembly. (See Figure 4-5)
4. Slowly release the spring assembly. Pivot the door
latch on the retaining pins so latch is 90 degrees to
the latch plate. Slide door latch off locating pins.
Inner Door Glass Removal
The inner door glass is secured with screws that pass
through two retaining covers that are mounted to the
inner door assembly.
To remove the inner door glass:
1. Remove door assembly from unit.
2. Remove the latch plate.
3. Using a #2 square bit screwdriver, extract the screws
from the two retaining covers and pull from door
assembly. (See Figure 4-6)
4. Lift the inner door glass from door assembly and
remove the rubber gasket from door glass.
Component Teardown
Locating
Pins
4-3
Latch Plate
Screws
Figure 4-4.
Screw
Figure 4-5.
Screws
Figure 4-6.