Diagnostics And Error Codes; Reading Error Codes; To Clear Latest Stored Error Code; Exiting Diagnostic Mode - Electrolux EIGD55H Technical & Service Manual

Electronic Control

Diagnostics and Error Codes

Acronyms:
MB – Main Board (Board located inside machine on right side just behind control panel.)
MC – Motor Control
UI – User interface board (board located inside the front control panel)
DL – Door Lock

Reading Error Codes

1. Wake the dryer up by pressing any button (except the cancel button).
2. Press and hold the "CANCEL" and "START/ PAUSE" buttons simultaneously for 6 seconds. The failure code will
appear in the display as an E followed by two numbers.
NOTE: E00 means no failure code experienced.
3. To view the last 5 error codes recorded, refer to the Diagnostic Mode listed below.
4. Troubleshoot problem by using the chart on page 3-20.

To Clear Latest Stored Error Code

Press the "CANCEL" button to enter standby mode and enable diagnostic entry.
1. Within 10 seconds after pressing "CANCEL", press any button to wake up the control.
'
2. Within 5 seconds of wake up, turn the selector knob to the far left cycle and press and hold the "CANCEL" and the
far left button under the display simultaneously for 3 seconds to enter the Diagnostic Mode.
NOTE: To save time at wake up, the welcome screen can be bypassed by turning the selector knob.
3. Turn the program knob counter clockwise 9 turns (clicks) from the Start Position. The control will signal the last 5
error codes with E00 meaning no error experienced.
4. Press and hold the far left key under the display and "CANCEL" buttons simultaneously for 3 seconds. The
code(s) will be cleared.
5. To return the washer to normal operation.
a) Unplug the power cord, wait 5-8 seconds, then reconnect the power cord OR
b) Turn the program knob clockwise 2 turns (clicks) back to the Start Position (LEDs are flashing).
Press the "CANCEL" and far left button under the display until the LEDs stop flashing.

Exiting Diagnostic Mode

To return the washer to normal operation:
1. Unplug the power cord, wait 5-8 seconds, then reconnect the power cord OR
2. Turn the program knob clockwise back to the Start Position. Press the "CANCEL" and far left button under the
display until the LEDs stop flashing.
3-18