Electronic Control
Control Panel (User Interface Layout) Wave-Touch™
Cycle Selector
User Interface
Display
Temperature
Extended Tumble
Dryness Level
Options Scroll
Figure 3-1. Wave-Touch™ Control Panel
Selecting the Appropriate Cycle and Settings Overview
Turn the cycle selector knob in either direction to select the cycle desired. The icon for that cycle will be illuminated
and if the cycle description feature is turned on, the cycle and estimated cycle time are displayed on the User Interface
screen for 5 seconds. Press any key to advance the User Interface to select settings and options.
Press any key or the User Interface screen will automatically advance after 5 seconds and display the preset drying
temperature, dryness level (Auto Dry) or drying time (Time Dry), extended tumble time, and options for the cycle
selected will be displayed.
To change the settings, press the temp, dryness level (Auto Dry) or drying time (Time Dry) and extended tumble
buttons to scroll to the desired settings. Press the scroll up or scroll down buttons under options to scroll through the
options menu. Press the select button to add or delete options. The estimated cycle time will be displayed at the top
of the screens.
Adjustments to a cycle will be remembered and recalled each time that cycle is selected in the future. To return to the
factory default settings, select RESET in set prefs under the options scroll buttons.
Demo Mode
Demo Mode will standby for 10 minutes then perform an LED on/off sequence for 3 minutes. During the standby
sequence the drum light and start button will be activated. The controls will be fully functional during Demo Mode
with abbreviated cycles lasting about 1 minute. Some features will be deactivated during Demo Mode for safety
purposes. When the units are in Demo Mode the text "DEMO MODE" will be displayed in the LCD screen. Demo
mode will be saved if the units are unplugged or if there is a power outage. To deactivate Demo Mode repeat steps
1-3 below.
NOTE: Set the controls to the desired language in the SET PREFS menu. After the unit has been set to DEMO
mode the language can not be changed.
1. Turn the cycle selector knob to TIME DRY cycle, press the START button then the CANCEL button.
2. Activate the controls by turning the cycle selector knob and turn to TIME DRY cycle.
3. Press and hold CANCEL button and EXTENDED TUMBLE (Third button from the left) for 3 seconds.
4. DEMO MODE instructions have to be completed by 7 seconds of the control activation.
5. Press the CANCEL button to begin DEMO MODE.
6. To deactivate DEMO MODE repeat steps 1 – 3.
3-1