Diagnostic Mode; To Start The Diagnostic Mode - Electrolux EIGD55H Technical & Service Manual

Diagnostic Mode

To Start the Diagnostic Mode

1. Press the "CANCEL" button to enter standby mode and enable diagnostic entry.
2. Within 10 seconds after pressing "CANCEL", press any button to wake up the control.
3. Within 5 seconds of wake up, turn the selector knob to the far left cycle and press and hold the "CANCEL" and the
far left button under the display simultaneously for 3 seconds to enter the Diagnostic Mode.
NOTE: To save time at wake up, the welcome screen can be bypassed by turning the selector knob.
4. Upon entering Diagnostic Mode, all lights should flash for IQ Touch™ models and all lights on for the Wave
Touch™ models.
5. The following steps can be cycled through by turning the selector knob clockwise:
Test Activated Component
Selector
Position
Electric
0 Lights / Buttons test
Motor Counter-Clockwise
1
(CCW)
2
Contact Sensor
3 Motor Clockwise (CW)
Lights / Buttons
4 Lights/Buttons
test + Motor CW
test + Motor
CW
Motor CW +
5
Heater
1
6 Motor CW +
Heater
1 + Heater 2
7 Motor CW
+ Heater1 +
Heater 2 +
Heater 3
8
Motor CW
9
Error code history display
10
Software version
11
Lights / Buttons test
Diagnostic Mode
Gas
Check Motor function. Look for Drum
rotation in counter-clockwise direction.
Check moisture reading. Place fingers
across Contact Sensor and look for digit
display to change from "1111" to "8888"
Check Motor function. Look for Drum
rotation in clockwise direction.
Check all buttons and lights. Press all
buttons and check for beep and button
ID number in digit display. Check to see
+ igniter
that all Lights function
Check Motor and Heater function. Check
Motor CW +
Outlet Control Thermistor value in digit
Heater
Check Motor and Heater function. Check
Motor CW +
Inlet Control Thermistor value in digit
Heater
Check Motor and Heater function. Check
Motor CW +
Outlet Control Thermistor value in digit
Heater
Check last 5 error codes displayed
(See Error Code Table )
Operator Check
display.
display.
display.
Check for Mist
Software version
3-19
Electronic Control
LCD row LCD digits
"MOTOR
CCW"
"MOIST. "1111" if Contact
BARS" Sensor open circuit;
"8888" if Contact
Sensor short circuited
"MOTOR
CW"
Button id number
Outlet Control
"HEAT1 -
Thermistor value
NTC1"
(degrees F)
Inlet Control
"HEAT2 -
Thermistor value
NTC2"
(degrees F)
Outlet Control
"HEAT3 -
Thermistor
NTC1"
value (degrees F)
"MIST
VALVE"
error code
Software
Software
version
version