Exhaust Thermal Limiter; Exhaust Tube; Outlet (Exhaust) Thermistor - Electrolux EIGD55H Technical & Service Manual

Exhaust Thermal Limiter Removal
(Electric and Gas Models)
The exhaust thermal limiter is mounted with screws to the
right side of the exhaust tube and is accessible from the
rear of the machine.
To remove the exhaust thermal limiter:
1. Remove the top panel, rear top brace and the rear
panel.
2. From the rear of the unit, disconnect the wire leads
from the exhaust thermal limiter terminals.
3. Using a #2 square bit screwdriver, extract the two
screws securing the exhaust thermal limiter to the
exhaust tube. (See Figure 4-33)
Exhaust Tube Removal (Electric and Gas Models)
The exhaust tube is secured at the rear of the unit with
a screw to the unit base. A rubber seal slides over the
connection between the exhaust tube and the blower
assembly.
To remove the exhaust tube:
1. Remove the top panel, rear panel, console, front
panel, front inner panel and drum.
2. Disconnect the wire leads from the exhaust thermal
limiter terminals. Slide rubber seal onto the exhaust
tube. (See Figure 4-34)
3. Using a #2 square bit screwdriver, extract the screw
securing the exhaust tube to the unit base. Pull tube
out of blower assembly outlet.
Outlet (Exhaust) Thermistor Removal
(Electric and Gas Models)
The outlet thermistor is mounted with a screw to the front
of the exhaust side of the blower outlet ducting.
To remove the outlet thermistor:
1. Remove the top panel, rear panel, console, front
panel, front inner panel and drum.
2. Disconnect the wire leads from the outlet thermistor
terminals.
3. Using a #2 square bit screwdriver, extract the screw
securing the outlet thermistor to the blower outlet
duct. (See Figure 4-35)
Component Teardown
Exhaust
Duct
Electrical
Connection
Blower Outlet Duct
Electrical
Connection
4-13
Screws
Figure 4-33.
Rubber Seal
Screw
Figure 4-34.
Screw
Figure 4-35.