Interior Light; Top Rear Brace; Rear Panel - Electrolux EIGD55H Technical & Service Manual

Interior Light Removal
The interior light is an LED assembly that is secured with
a tab that secures the assembly to the inner front panel.
The wire leads for the interior light are disconnected at
the control assembly.
To remove the interior light:
1. Remove the trim ring, door assembly and the air
duct cover.
2. Remove the top panel, console and front panel.
3. Disconnect the wire leads at the control assembly.
4. Rotate interior light assembly until tab can be
pushed through the inner panel, then pull assembly
and wire leads through the compartment opening.
(See Figure 4-22)

Top Rear Brace

The top rear brace is secured with fi ve screws to the top
and rear of the unit frame.
To remove the top rear brace:
1. Pull the unit from its installation position and
remove the top panel.
2. Using a #2 square bit screwdriver, extract
the three screws from the lower edge of the
top rear brace. (See Figure 4-23)
3. From the top edge, extract the screw from
each corner of the top rear brace and remove
from unit.
Rear Panel Removal
The rear panel is secured with 21 screws to the unit
frame. The exhaust duct will need to be removed prior to
removing the rear panel.
To remove the rear panel:
1. Pull the unit from its installation position and remove
the top panel and rear top brace.
2. Using a #2 square bit screwdriver, extract the 21
screws ( Labeled "A" in Figure 4-24) securing the
rear panel to the rear of the unit. Remove the rear
panel from unit.
Component Teardown
4-9
Rotate Tab
LED Assembly
Figure 4-22.
Screws
Figure 4-23.
Figure 4-24.