Install Cycle (Wavetouch™); Install Cycle (Iq Touch™) - Electrolux EIGD55H Technical & Service Manual

Wave-touch & iq-touch front-load dryer
Hide thumbs Also See for EIGD55H:
Table of Contents

Advertisement

Install Cycle (WaveTouch™)
1. After plugging in the dryer the first time: wake up
the dryer by pressing any button and then follow the
prompts on the LCD User Interface, including
language selection.
2. The Installation Cycle will automatically test for
correct cord connection (on electric models),
presence of gas supply (on gas models) and free
flow of exhaust vent. At cycle completion, the
LCD user interface may display INSTALL PASS!,
meaning the dryer is properly installed and ready
for use. If it prompts an action such as SERVICE
CORD, NO GAS or Call Service 877-435-3287,
review the installation steps and make the
necessary corrections before attempting to use the
dryer.
3. The dryer will exit the Installation Cycle and return to
normal operation the next time the dryer is used.
Install Cycle (IQ Touch™)
1. Empty dryer's drum and close door.
2. After you plug in the dryer the first time: wake up
the dryer by pressing any button, rotate cycle knob
to touch up cycle, press the start button and then
the cancel button.
3. Wake up the dryer again by pressing any button,
then immediately and simultaneously press and
hold both the sanitize and my favorite buttons for 5
seconds, or until the LCD display changes.
4. The LCD window will display INSTAL CYCLE
and show estimated time of cycle completion.
Press the start button. The Installation Cycle will
automatically test for correct cord connection (on
electric models) and presence of gas supply (on
gas models). At cycle completion, the LCD window
may display INSTAL PASS!, meaning the dryer is
properly installed and ready for use. If it prompts
an action such as SERVICE CORD, NO GAS or
Call Service 877-435-3287, review the installation
steps and make the necessary corrections before
attempting to use the dryer.
5. The washer will exit the Installation Cycle and
return to normal operation the next time the
washer is used.
The INSTALL CYCLE is prompted automatically only
once when the dryer is turned on the first time at the
end of installation. After that, if you wish to run a
subsequent INSTALL CYCLE when moving the dryer
or modifying your installation, you may perform your
own INSTALL CYCLE by selecting it in the set prefs
feature and then following the screen prompts.
Dryer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run the
dryer through a drying cycle, press the cancel button
to put the unit to sleep and then rewake it immedi-
ately, to continue the normal operating mode.
The errors may result from the following
conditions:
• SERVICE CORD error (electric dryer)—The power
supply cord has been installed improperly or the house
wiring to the receptacle is incorrect.
• NO GAS error (gas dryer)—There is no connection
between the dryer and the gas line or the valve is closed.
• CALL SERVICE—Troubleshoot and repair as needed.
Repeat the INSTALL CYCLE when corrections are
completed.
3-15
Electronic Control

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ewed65hEied55hEwgds65hEwmed65hEwmgd65h

Table of Contents