Table of Contents
Advertisement
22
www.electrolux.com
22
www.electrolux.co.th
5.4 Starting A Cycle (
To start a program, press the Start/Pause
touchpad. The corresponding pilot light
will stop flashing and a default program
duration will be displayed on the screen.
After approx. 15 minutes from the start of
a program:
The appliance will automatically adjust
−
the selected program duration
according to the type and size of the
load.
−
The display will show adjusted
program duration.
NOTE
If you press any touchpad while a
program is operating, the symbol "
will flash on display along with buzzer
sound. (except Start/Pause touchpad and
On/Off button)
5.5 Interruption Of A Program
−
To pause, press Start/ Pause.
The indicator will start flashing.
−
Press the Start/Pause again.
The program will continue.
5.6 Changing A Program
Changing a running program is possible
only by switching off the appliance.
−
Press the "On/Off" button to cancel
the program and to turn off the
appliance.
−
Press the "On/Off" button again to
start the appliance.
Now you can set a new wash program
and change any available options. Press
Start/Pause to start the new program.
NOTE
The appliance will not drain the water
(except programs; Hygienic Care, Spin,
Rinse + Spin).
)
5.7 Changing The Options
It may be possible to change some of the
options after a program has started.
1.
Press the touchpad Start/Pause. The
indicator will start flashing.
If available change the options that
2.
you wish.
Press Start/Pause again. The program
3.
will continue.
5.8 Opening The Door
While a program or the Delay Start is
operating, the appliance door is locked
and the display shows the indicator "
First, set the machine to PAUSE by
"
pressing the "Start/Pause" touchpad. Wait
until the door lock indicator goes off, then
the door can be opened.
If the door lock indicator "
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or the
drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
In case of Remote (
activated, when program cycle end and
anticrease phase is complete. The door
will remain locked for 5 minutes, if you
want to open the door at that time, press
Remote (
function then the door is unlocked.
In case of emergency please
refer to "Emergency door
opening" on page 39.
" does not
) function is
) touchpad once to turned off
".
Advertisement
Table of Contents
