Roller Assembly; Front Air Duct - Electrolux EIGD55H Technical & Service Manual

Component Teardown
Roller Assembly Removal
There are fi ve roller assemblies that the dryer drum rides
upon. The roller shafts are secured to the outside of the
inner panels by a 9/16" nut. The rollers slide onto the
roller shafts and are secured with triangular retainers.
To remove the roller assemblies:
1. Remove the top panel, rear panel, console, front
panel, front inner panel and drum.
NOTE: With the drum removed, all roller assemblies
are accessible. Figure 4-32 illustrates the front roller
assemblies.
2. Using a 9/16" socket or wrench, remove the nut from
the roller shaft securing it to the inner panel. A 3/8"
wrench can be used on the opposite end of the shaft
to stop the shaft from turning while loosening and
tightening the nut. (See Figure 4-31)
3. Pull roller assembly from inner panel.
4. Use a small flat bladed screwdriver and remove the
triangular retainer from the roller shaft. Pull the roller
from the roller shaft.
Front Air Duct Removal
The front air duct is secured with three screws to the
inner front panel. The two screws behind the rollers are
only accessible with the inner panel removed from the
unit.
To remove the front air duct:
1. Remove the top panel, rear panel, console, front
panel, front inner panel and drum.
2. From the backside of the front inner panel, use
a small flat bladed screwdriver and remove the
triangular retainer from the two roller shafts. Pull the
rollers from the roller shafts.
3. Using a #2 square bit screwdriver, extract the three
screws securing the front air duct to the front inner
panel. (See Figure 4-32)
Inner
Panel
9/16"
Washers
Nut
4-12
Retainers
Figure 4-31.
Screw
Rollers

Front Air Duct

Figure 4-32.
Roller