Wave-Touch™ Installation Cycle; Iq -Touch™ Installation Cycle - Electrolux EIGD55H Technical & Service Manual

Installation Information
Wave-Touch™ Installation Cycle
1. After plugging in the dryer the first time: wake up
the dryer by pressing any button and then follow the
prompts on the LCD User Interface, including
language selection.
2. The Installation Cycle will automatically test for
correct cord connection (on electric models),
presence of gas supply (on gas models) and free
flow of exhaust vent. At cycle completion, the
LCD user interface may display INSTALL PASS!,
meaning the dryer is properly installed and ready
for use. If it prompts an action such as SERVICE
CORD, NO GAS or Call Service 877-435-3287,
review the installation steps and make the necessary
corrections before attempting to use the dryer.
3. The dryer will exit the Installation Cycle and
return to normal operation the next time the
dryer is used.
IQ -Touch™ Installation Cycle
1. Empty dryer's drum and close door.
2. After you plug in the dryer the first time: wake up the
dryer by pressing any button, rotate cycle knob to
touch up cycle, press the start button and then the
cancel button.
3. Wake up the dryer again by pressing any button,
then immediately and simultaneously press and
hold both the sanitize and my favorite buttons for 5
seconds, or until the LCD display changes.
4. The LCD window will display INSTAL CYCLE
and show estimated time of cycle completion.
Press the start button. The Installation Cycle will
automatically test for correct cord connection (on
electric models) and presence of gas supply (on
gas models). At cycle completion, the LCD window
may display INSTAL PASS!, meaning the dryer is
properly installed and ready for use. If it prompts an
action such as SERVICE CORD, NO GAS or
Call Service 877-435-3287, review the installation
steps and make the necessary corrections before
attempting to use the dryer.
5. The washer will exit the Installation Cycle and
return to normal operation the next time the washer
is used.
Dryer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run
the dryer through a drying cycle, press the cancel
button to put the unit to sleep and then rewake
it immediately, to continue the normal operating
mode.
2-14