When The Washing Program Is Completed, But There Is Water In The Drum; Auto Off Mode - Electrolux EWW8024E3WB User Manual

NOTE
At the end of the program, the time
remaining can suddenly decrease from
7 minutes or less to 0 due to the
overestimated total program time during
the load sensing phase. In some cases
(with perfectly balanced load) the
program time can be shorter than the
time estimated after the load sensing
phase is completed. This is a normal
behavior of the machine and not a
cause for concern as it does not
compromise its performance.
5.10 When The Washing
Program Is Completed, But
There Is Water In The Drum
(Option "Rinse Hold
-
The drum turns regularly to prevent
the creases in the laundry.
-
The indicator "Start/Pause" flashes to
remind you to drain the water.
-
The door lock indicator "
The door stays locked.
You must drain the water to
open the door.
To drain the water:
1. Press the "Start/Pause
The appliance drains the water and
spins with the maximum spin speed
for selected program.
Alternatively, before pressing the
"Start/Pause" touchpad, you can press
the "Spin " touchpad to change the
spin speed. You can select "No Spin
( )", if you want the machine to only
drain the water.
When the program is completed and
2.
the door lock indicator "
you can open the door.
turn the program selector knob to the
3.
position "Off" to deactivate the
appliance.
" is used)
" is on.
" touchpad.
" goes off,
NOTE
After approximately 18 hours, if you do
not press Start/Pause touchpad, the
appliance will drain and spin automatically
(except for "Wool" program) .

5.11 AUTO Off Mode

The AUTO Standby mode automatically
deactivates the appliance to decrease
the energy consumption when:
You do not press any buttons for
5 minutes before you press
"Start/Pause ".
- All indicators and the display will
switch off.
-
The indicator of the touchpad
"Start/Pause
Press any touchpad to reactivate
the appliance.
5 minutes after the washing program
ends, if you do not deactivate the
appliance, the energy saving function
activates.
-
All indicators and the display will
switch off.
- The indicator of the touchpad
"Start/Pause
Press any touchpad to
reactivate the appliance.
-
Display will show the end of the last
wash.
-
Press any touchpad again to show
the last wash program.
-
Turn the selector knob to set a new
wash program.
ENGLISH
" will flash slowly.
" will flash slowly.
21