Model With Base - Motorola DS6708 Product Reference Manual

Model with Base

Installing the Interface Cable
Turn both angle adjustment knobs left to loosen the scanner in the base. See
1.
Move the scanner forward until there is full access to the cable interface port on the bottom of the scanner.
2.
See Figure 1-3 or
Adjust the Scanner for Cable Installation
Figure 1-6
Insert the interface cable through the opening at the back of the base.
3.
NOTE Ensure the cable is inserted through the opening at the back and not underneath the base.
Plug the interface cable modular connector into the cable interface port on the bottom of the scanner
4.
handle.
Gently tug the cable to ensure the connector is properly secured.
5.
Move the scanner to preferred angle and turn the angle adjustment knobs right to tighten.
6.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
7.
NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
Connectors vary from those illustrated, but the steps to connect the digital scanner are the same.
Removing the Interface Cable for Scanner with Base
Turn both angle adjustment knobs left to loosen the scanner in the base. See
1.
Move the scanner forward until there is full access to the cable interface port on the bottom of the scanner.
2.
Using the tip of a screwdriver, depress the cable's modular connector clip. See
3.
Carefully slide out the cable.
4.
Follow the steps for
5.
Move the scanner to preferred angle and turn the angle adjustment knobs right to tighten.
6.
Figure 1-5.
Angle Adjustment Knob (2)
Installing the Interface Cable to connect a new cable.
Getting Started 1 - 5
Figure 1-6.
Figure 1-6.
Figure 1-4.