5 - 2
DS6708 Digital Scanner Product Reference Guide
Scanning Sequence Examples
In most cases scanning one bar code sets the parameter value. For example, to disable the decode aiming
pattern, scan the Disable Decode Aiming Pattern bar code listed under
The digital scanner issues a fast warble beep and the LED turns green, signifying a successful parameter
entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Decoding Preferences Parameter Defaults
Table 5-1
lists the defaults for decoding preferences parameters. There are two ways to change the default
values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Configure the digital scanner using the 123Scan
NOTE See
miscellaneous default parameters.
Decoding Preferences Parameter Defaults
Table 5-1
Parameter
Decoding Options
Decoding Illumination
Illumination Bank Control
Decode Aiming Pattern
Low Light Enhancement
Presentation Mode Field of View
Appendix A, Standard Default Parameters
Set Default Parameter on page
2
configuration program (see
for all user preferences, hosts, symbologies, and
Parameter
Number
F0h 2Ah
Enable
F1h 3Bh
Full Illumination
F0h 32h
Enable
F1h 64h
Disable
F1h 61h
Default (Reduced)
Decode Aiming Pattern on page
4-4.
Chapter 12,
123Scan2).
Default
5-3
5-4
5-5
5-5
5-6
5-5.
Page
Number