Cushman 632904 Service Manual page 74

ELECTRONIC SPEED CONTROL
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
If the continuity test indicates that contacts are not
B
"welded" and the wiring to the solenoid coil is good, the
coil has failed and the solenoid must be replaced.
Fig. 6 Continuity Check of Solenoid
Page G-6
TROUBLESHOOTING DIAGRAMS
The following diagrams will assist in servicing the vehi-
cle. By utilizing the Fault Codes, considerable time will
be saved in determining the probable vehicle operating
malfunction. The vehicle power and control wiring dia-
gram is included for your convenience in tracing the
electrical wiring (Ref Fig. 10). The following charts will
assist in diagnosing and correcting problems not diag-
nosed through the Fault Codes.
Repair and Service Manual