Parking Brake; Adjustment; Cable Replacement - Cushman 632904 Service Manual

BRAKES
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

Adjustment

B
To adjust the parking brake, loosen the screw in the end
of the lever and turn the knob to tighten or loosen ten-
sion on the brake cable.
Switch is installed with a magnet holder, adjustment of
switch to maintain a gap of .15" - .25" with link installed for
positive actuation.

Cable Replacement

Cables should be replaced when they become inopera-
ble. Cable replacement consists of first loosen jam nut
which holds the brake cable through clamp, then remove
the washer, cotter and clevis pin that securing the cable to
the connecting link and side plate. Then remove the two
cotter and clevis pins securing the cable to the connecting
link and park brake lever. Install new cable in reverse
order of removal and adjust parking brake system per
instructions above (Ref. Fig. 8).
Page E-10
Side Plate
Clevis Pin
Repair and Service Manual
Adjustment Knob
Magnetic
Switch
Brake Lever Assembly
Assembly
Connecting
Link
Spacer
Clamp
Brake Cable
Parking
Brake
Boot
Fig. 8 Parking Brake System Components
Magnetic
Assembly
Side Plate
Pivot
Fastener
Pivot Nut
Cotter Pin
Jam Nut
Brake
Cable
Clevis Pin
Mounting
Bracket
Cotter Pin