Wheel Installation - Cushman 632904 Service Manual

WHEELS AND TIRES
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

Wheel Installation

B
Do not tighten lug nuts (1) to more than 85 ft. lbs. (115
Nm) torque.
It is important to follow the 'cross sequence' pattern when
installing lug nuts. This will assure even seating of the wheel
against the hub.
Page N-2
NOTICE
Tire style may vary
1
4
Fig. 1 Wheel and Tire Installation
Repair and Service Manual
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts (1). Finger tighten lug nuts (1) as
shown. Then, tighten lug nuts to 50 - 85 ft. lbs. (70 - 115
Nm) torque in 20 ft. lbs. (30 Nm) increments following
the same pattern.
ITEM NO
1
3
3
2
5
'Cross Sequence'
TORQUE SPECIFICATION
50 - 85 ft. lbs. (70 - 115 Nm)
1
Valve Stem Cap
1
4
2