Cushman 632904 Service Manual page 151

NOTICE
Read the following warnings before attempting to operate the
vehicle:
To prevent personal injury or death, observe
the following:
When vehicle is to be left unattended, engage
park brake, move direction selector to neutral,
turn key to 'OFF' position and remove key.
Drive vehicle only as fast as terrain and safety
considerations allow. Consider the terrain and
traffic conditions. Consider environmental fac-
tors which effect the terrain and the ability to
control the vehicle.
Avoid driving fast down hill. Sudden stops or
change of direction may result in a loss of con-
trol. Use service brake to control speed when
traveling down an incline.
Use extra care and reduced speed when driv-
ing on poor surfaces, such as loose dirt, wet
grass, gravel, etc.
All travel should be directly up or down hills.
Use extra care when driving the vehicle across
an incline.
Stay in designated areas and avoid steep
slopes. Use the park brake whenever the
vehicle is parked.
Keep feet, legs, hands and arms inside
vehicle at all times.
Avoid extremely rough terrain.
Check area behind the vehicle before
operating in reverse.
Make sure the direction selector is in correct
position before attempting to start the vehicle.
Slow down before and during turns. All turns
should be executed at reduced speed.
Always bring vehicle to a complete stop
before shifting the direction selector.
See GENERAL SPECIFICATIONS for vehicle
load and seating capacity.
NOTICE
Read and understand the following text and warnings before
attempting to service vehicle:
In any product, components will eventually fail to per-
form properly as the result of normal use, age, wear or
abuse.
It is virtually impossible to anticipate all possible compo-
nent failures or the manner in which each component
may fail.
Be aware that a vehicle requiring repair indicates that
the vehicle is no longer functioning as designed and
therefore should be considered potentially hazardous.
Use extreme care when working on any vehicle. When
diagnosing, removing or replacing any components that
are not operating correctly, take time to consider the
safety of yourself and others around you should the
component move unexpectedly.
Some components are heavy, spring loaded, highly
corrosive, explosive or may produce high amperage or
reach high temperatures. Battery acid and hydrogen
gas could result in serious bodily injury to the techni-
cian/mechanic and bystanders if not treated with the
utmost caution. Be careful not to place hands, face, feet
or body in a location that could expose them to injury
should an unforeseen situation occur.
Always use the appropriate tools listed in the tool list
and wear approved safety equipment.
Before working on the vehicle, remove all jew-
elry (rings, watches, necklaces, etc.)
Be sure no loose clothing or hair can contact
moving parts.
Use care not to touch hot objects.
Raise rear of vehicle and support on jack
stands before attempting to run or adjust pow-
ertrain.
Wear eye protection when working on or
around the vehicle. In particular, use care
when working around batteries, using
solvents or compressed air.
Hydrogen gas is formed when charging
batteries. Do not charge batteries without
adequate ventilation.
Do not permit open flame or anyone to smoke
in an area that is being used for charging bat-
teries. A concentration of 4% hydrogen gas or
more is explosive.