Direction Selector Switch; Power On/Battery Condition Meter; Headlight (Accessory); Service/Parking Brake Pedal - Cushman 29175-G01 Owner's Manual And Service Manual

ELECTRIC THREE WHEEL SERVICE VEHICLE
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
ON POSITION: Supplies power
OFF POSITION: Interrupts power (Ref Fig. 7 on page 4)
2

Fig. 7 Key Switch

1. On Position
2. Off Position
!
always turn the key switch to the OFF position and
remove the key when the vehicle is not in use.

Direction Selector Switch

The direction selector switch, located on the dash panel,
controls the direction of vehicle movement. The panel is
marked with FORWARD, NEUTRAL and REVERSE
positions. Push to the NEUTRAL position when leaving
the vehicle seat.
Fig. 8 Direction Selector Switch
!
next operate the vehicle, ALWAYS place the direction
selector switch in the NEUTRAL position when leav-
ing the vehicle seat.
Remove the key to prevent unauthorized use of the
vehicle.
Page 4
1
To prevent unexpected
!
vehicle movement or
u n a u t h o r i z e d
NEUTRAL
REVERSE
To prevent unexpected
!
vehicle movement when
you or other persons
Owner's Manual and Service Guide

Power ON/Battery Condition Meter

The power on/battery condition meter indicates whether
power is supplied to the unit and the state of battery
charge. The meter illuminates only when power is being
supplied.
The meter scale is a 10--bar LED (light emitting diode)
displaying the state of charge successively, bar by bar,
from full to empty.
•
At 70% of discharge, a flashing light signals an
"energy reserve" alert.
•
At 80% of discharge, a double flashing light sig-
nals as "empty" alarm. The batteries should be
fully charged before using the vehicle.

Headlight (Accessory)

The headlight can be pivoted on the mounting as
required. Push the headlight switch on the dash panel to
turn the headlight on or off.

Service/Parking Brake Pedal

u s e ,
The service and parking brakes are combined in the left
pedal on the floorboard. Depressing the pedal will slow
or stop the vehicle. Once the vehicle has stopped, the
parking brake can be engaged by pressing the front por-
tion of the pedal.
The floorboard catch should engage in the first notch of
the parking brake lock catch when the brake is properly
adjusted. (Ref. Fig. 9 on page 4).
DEPRESS TO
RELEASE PARKING
BRAKE
FRONT OF VEHICLE
FLOORBOARD
FLOORBOARD CATCH
To release the parking brake, depress the service/park-
ing brake pedal.
DEPRESS TO ENGAGE
PARKING BRAKE CATCH
Fig. 9 Speed Control Pedal
PARKING BRAKE
LOCK CATCH
FIRST NOTCH