Setting The Address Print Position - Rena Envelope Imager I Instruction Manual

5.8 Setting the address print position

Before setting your desired address position, you must know which areas
the printer can reach.
The address height is positioned by shifting the print unit. The printable area
results from the neces sary margins and the offset path of the print unit:
X+Y = 2 mm (0.078) with Flashware V9.xx or ↑
X+Y = 56 mm (2.205) with Flashware V5.xx or ↓
Unprintable area
The upper margin of 15 mm shown here can be reduced to 0 mm if
required. To do this, shift the rear contact bracket onto the red mark. You
can now print without margins.
1
Maximum print width depends on width of piece and version of Flashware installed.
612s(Ei1)_Operations Rev: 5/12/03
RENA Address Printer
1
Print area Offset area of
print unit
15 mm
(0.6 )
inch
21