Hardware Test - Rena Envelope Imager I Instruction Manual

HexD
This function is used to check the connection from the printer to the PC
and for troubleshooting software problems. In hex-dump, all characters
currently being received from the receive buffer are printed in LetGot12.
Prints out data that is currently being received.
You can also switch hex-dump on directly by keeping the start key
pressed and then switching the printer on.
Do not end hex-dump by switching the printer off, as settings may then
be changed! End it by pressing the prog, end or start keys.
InpD
Input-Dump. All 96 Kbytes of the receive buffer are printed with PC8-
symbols. Prints out data that has already been received.
The complete print-out requires approximately 180 sheets. Switch the
printer off before a dump print-out and then on again. Transmit the print
job and then start the dump print-out. The required data are now at the
beginning of the buffer. Stop the process by pressing the end key.
SetD
Print-out of the 10 setting configurations. Nine sheets are required.

HARDWARE TEST

For service use only.
HEAD RESET
Resetting the display for used ink (% of ink) after inserting the new print
cartridge(s).
Whenever a new ink cartridge is placed into the printer, you should reset
the counter for the corresponding cartridge position you are replacing.
Tip! The ink counter is only accurate if the customer follows these steps:
§
Reset the ink counter whenever a new ink cartridge is installed.
§
Return cartridges to original positions. Since it is necessary to
remove, clean and store ink cartridges, to maintain good print
quality, you must mark the cartridges to make sure the same ink
cartridge is always placed back into the same location.
612s(Ei1)_Operations Rev: 5/12/03
RENA Address Printer
38