Panasonic HMWIN User Manual page 299

Resize Image Area
Download
Configuration OS
Download Main OS
Download Splash
Image
Download
Bootloader
Download Main
FPGA
Download Safe
FPGA
Download System
Supervisor
Operation with the System Settings Tool is critical and, when not performed correctly, may
IMPORTANT
cause product damages requiring service of the product. Ask Technical Support for further details.
When executed in "System Mode" the System settings also provide the "BSP Settings". Only when recalled
from the System Mode, the BSP settings show an additional tab called "Password" as shown in the figure
below.
Figure 309
ACGM0195V1EN
HMWIN Studio User Manual
Not all targets and BSPs contain all these options.
NOTE
Resizes the Flash portion reserved to store the splash screen image that
is displayed at power up. Default settings are normally ok for all units.
checks the actual version and upgrades the back-up operating system
(see relevant chapter, for additional details)
checks actual version and upgrades the main operating system (see
relevant chapter for additional details)
Loads a new file for the splash screen image displayed by the unit at
power up; the image must be supplied in a specific format. We suggest
that you update the splash screen image directly from the HMWIN Studio
programming software.
Checks the actual version of the system boot loader and upgrades the
system boot loader.
Checks the actual version and upgrades the main FPGA file; this
command may not be available in all platforms and versions.
Checks the actual version and upgrades the back-up (safe) copy of the
FPGA file; this command may not be available in all platforms and
versions.
Checks the actual version and upgrades the system supervisor firmware
(used for the RTC and power supply handling).
299