Table of Contents
Advertisement
22.4 Configuring Users
To configure users double click on Users from the Project View, and then click on the + sign to add a new
user. A user named admin is already present by default and this user cannot be deleted.
Figure 201
Name
Default User
Group
Password
Change Initial
Password
Comments
Logoff time (In
Min)
Minimum Length
Must Contain
Special Characters
Must Contain
Numbers
22.5 Default User
You can program a Default User for a project. When the system starts or reboots, the Runtime is logged in
with the default user. All the privilege settings of the default user will be activated in the system. If you want
to log in as a different user in Runtime, you can use either the Switch User macro or the Log Off macro.
The default user will automatically get logged in if any user (other than default user) logs off.
ACGM0195V1EN
HMWIN Studio User Manual
User Name
Identifies the user which is automatically logged-in by the system when
starting, re-starting or after a logout; only one default user is allowed.
Groups of the user. Groups are used to assign authorizations to users.
Password for the user
If True, the user is forced to change his password on first logon
Comments for the user
The user will be automatically logged off after the specified time with no
actions on the panel. After Log off, the Runtime goes to the default user.
The minimum length of the password. It should be equal or greater than
the set value.
If True, the password should contain at least one special character
If True, the password should contain at least one numeric digit.
193
Advertisement
Table of Contents
