Table of Contents
Advertisement
Figure 101
9.10.9 CopyCodesysProject
The action CopyCodesysProject copy the CODESYS 2.3 project files (.prg, ,chk and .sdb) located in the
source path into the panel CODESYS folder. Files are automatically renamed to DEFAULT.CHK ,
DEFAULT.PRG , BOOT.SDB if it is of different name.
After copy of files the CODESYS module is stopped, reloaded and started again.
Parameters:
Source Path
Copy Symbols if set to true copy also .SDB symbols file (used by CODESYS 2 ETH protocol).
To generate CODESYS project files, proceed as follow from CODESYS:
1) Execute Project -> Rebuild All (to generate an updated SDB symbol file)
2) Execute Online -> Create boot project (to generate the .CHK and .PRG files)
The CopyCodesysProject action can be used also to transfer a CODESYS project from one hmi panel to
another. In this case files needed from hmi running CODESYS project are following:
- DEFAULT.CHK
- DEFAULT.PRG
- BOOT.SDB
Using System variables PLC -> PLC Status and PLC -> Get CopyCodesysProject Action Status the
status of PLC and of CopyCodesysProject action can be verified.
ACGM0195V1EN
HMWIN Studio User Manual
path of project into external storage. Ex. \USBMemory\Codesys
106
Advertisement
Table of Contents
