Table of Contents
Advertisement
Various settings (continued)
Multiplexer settings
You can confi gure the multiplexer settings for Output A and
Output B individually.
Output A/Output B
You can set the camera numbers displayed on the split
screen on the monitor connected to OUTPUT A or OUTPUT
B. (The settings of Output A are applied to OUTPUT A,
and those of Output B to OUTPUT B.) You can also make
sequential display settings. Sequential display is a function
to automatically switch the displayed images from the
selected cameras at constant intervals.
1 Select [Setting] next to the output you want to
Step
set (Output A or Output B).
The screen for setting the selected output is
•
displayed.
Copy Output A settings
You can copy the settings of Output A to Output B.
1 Select [Execute] next to [Copy Output A settings].
Step
Select [Yes] on a confi rmation screen.
•
4-split screen to 16-split screen
4-split screen
9-split screen
Set the camera numbers to be displayed on each split screen.
You can select different cameras for Output A and Output B.
1 Select [Setting] next to the split screen mode you
Step
want to change.
The screen for setting the selected split screen mode
•
is displayed.
2 Left-click repeatedly on the number until the
Step
desired camera number appears.
Numbers from 1 to 16 and [- -] are displayed.
•
Notice
•
You cannot set more than one same camera number
within the same split screen mode.
•
When you select [- -], the camera number is displayed
as [--] on the normal screen.
110
<Multiplexer setting>
10-split screen
13-split screen
16-split screen
Sequential display
Example
When you make settings as
follows:
Split 4a: Camera numbers 1 to 4
Split 4b: Camera numbers 5 to 8
Split 4c: Camera numbers 9 to 12
Split 4d: Camera numbers 13 to 16
Sequential display: 4abcd
Display interval: 2 seconds
The screen display automatically switches.
1 Select [Setting] next to [Sequential display].
Step
The screen for setting the sequential display is
•
displayed.
2 To set the display order in the single-screen
Step
sequential display mode, set [Single sequential
display].
When you click on the number, it changes from 1 to
•
16 and [- -] in order.
3 To set the display order in the split-screen
Step
sequential display mode, set [Split sequential
display].
4 To set the display switching interval in the
Step
sequential display mode, designate the desired
interval in [Display interval].
Alarm display
When an alarm signal is input, the single screen or 4-split
screen is displayed according to the pre-designated
selection. When another alarm signal is input during alarm
recording, the images from the cameras recorded upon
input of the latest alarm signal are displayed on the single
screen or 4-split screen. After the completion of the alarm
recording, the screen returns to the original display mode.
Example
During
normal recording
A trigger for alarm recording
selected by the recording setting is input.
Displayed on the
9-split screen
1 Select the output for activating the alarm display
Step
function.
[Off]: Alarm display function is disabled.
2 Select the screen display mode to be used when
Step
an alarm signal is input for each of the connected
sensors.
Setup menu
2 seconds
1
2
5
6
later
3
4
7
8
2 seconds
2 seconds
later
later
13
14
9
10
15
16
11
12
2 seconds
later
During
alarm recording
The screen automatically
switches to either the single
screen display or 4-split
screen display according to
the pre-determined selection.
Advertisement
Table of Contents
Troubleshooting
