Before Making Recording Settings; Playback During Recording - Mitsubishi Electric DX-TL5716U Installation Manual

Before making recording settings

Notice
• Because the recorder copies or searches recorded
data based on the date and time of recording, check
that the recorder's clock is correct before you start
recording.
• You cannot change the recording settings during
normal recording and alarm recording. To change the
settings, stop recording. When alarm recording by
motion detection is enabled, recording may not be
stopped because of frequent alarm inputs. In this case,
set [Alarm input] to [Off] on the <Recording settings>
screen to temporarily prohibit alarm input (for max. 5
minutes). ( Page 65)
• It is necessary to check the repeat recording settings
before you start recording. Check the repeat recording
settings and then make the recording settings. (
Page 40)
• The warning display saying "Camera image is lost
or distorted" appears when the video signal is lost or
an error is detected even while the recorder is not in
recording. This warning is issued for the cameras set
for normal, alarm, and emergency recordings. Exclude
unused cameras from the recording setting.

Playback during recording

You can play back already recorded data while continuing
recording.
Notice
• Images being played back may be stopped temporarily
or the audio may be interrupted.
• Noise may appear in the images during playback
using the jog/shuttle.
Tips
• The layout on the split screen is saved individually for
live and playback.
Recording
49