Ac Mains Supply - Roksan Audio K3 User Manual

Your K3 Integrated Amplifier is set to operate from a fixed supply voltage
which is marked on a label next to the mains input plug. Before connecting
the mains lead please check that your mains supply corresponds to the
label as below:
230V Products: Voltage Range 220V – 240V
115V Products: Voltage Range: 110V – 120V
100V Products : Voltage Range: 90V – 110V
The mains lead supplied with this product has an IEC mains socket which
plugs into the IEC connector on the unit's rear panel. The other end is
normally attached to the appropriate mains plug for your country. In the UK
this is the standard UK13A plug.
This plug should ordinarily not be removed from the lead. If you do remove
it, please dispose of it safely so that it cannot be plugged into a mains
socket whilst in a potentially dangerous condition. We suggest that you
obtain from your dealer a complete set of replacement leads.
Should you move to another area where either the mains voltage or the
mains plug are different from those as supplied with your Integrated
Amplifier, please contact the appointed ROKSAN distributor for assistance.
Please observe correct mains polarity at all times.
The Integrated Amplifier mains fuse is located on the rear panel next to the
IEC mains connector. This must only be replaced by the fuse of the type and
rating as described on the fuse rating label on the rear panel of the unit.
!
This product requires connection to earth (ground). The earth wire (in the
UK this is colour coded green/yellow) of the mains cable supplied with your
Integrated Amplifier must be connected to a suitable earthing point
established for this purpose by your electricity supply company. If you are in
any doubt, consult a qualified electrician.
If the equipment is likely to be unattended for some time, unplug it from the
mains supply.
Page 4
!
!
!
Cautions

AC Mains Supply

!
!
Roksan Audio Ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE