Ac Mains Supply; General Cautions - Roksan Audio Kandy K2 BT User Manual

C A U T I O N S

AC MAINS SUPPLY

Your Kandy K2BT Integtrated Amplifier is set to operate from a fixed supply voltage which is marked on a label next to
the mains input plug. Before connecting the mains lead please check that your mains supply corresponds to the label
as below:
230V Products ........................................Voltage Range: 220V – 240V
115V Products ........................................Voltage Range: 110V – 120V
100V Products ........................................Voltage Range: 90V – 110V
The mains lead supplied with this product has an IEC mains socket which plugs into the IEC connector on the unit's rear
panel. The other end is normally attached to the appropriate mains plug for your country. In the UK this is the standard
UK13A plug.
This plug should ordinarily not be removed from the lead. If you do remove it, please dispose of it safely so that it cannot
be plugged into a mains socket whilst in a potentially dangerous condition. We suggest that you obtain from your dealer
a complete set of replacement leads.
Should you move to another area where either the mains voltage or the mains plug are different from those as supplied
with your Integrated Amplifier, please contact the appointed ROKSAN distributor for assistance.
Please observe correct mains polarity at all times.
The Integrated Amplifier mains fuse is located on the rear panel next to the IEC mains connector. This must only be
replaced by the fuse of the type and rating as described on the fuse rating label on the rear panel of the unit.
This product requires connection to earth (ground). The earth wire (in the UK this is colour coded green/yellow) of the
mains cable supplied with your Integrated Amplifier must be connected to a suitable earthing point established for this
purpose by your electricity supply company. If you are in any doubt, consult a qualified electrician.
If the equipment is likely to be unattended for some time, unplug it from the mains supply.

GENERAL CAUTIONS

FCC Warning
This equipment may generate or use Radio Frequency energy. The user may lose the right to operate this equipment if
unauthorised modifications are made.
Interference
Properly installed, this unit should not cause harmful interference to radio communications. There is, however, no
guarantee that such interference will not occur in a specific installation. If interference arises (which you can determine
by switching the unit off and on) you could try to remedy matters by using the following methods:
• Re-orient or re-locate the receiving antenna.
• Increase the distance between the Kandy Integrated Amplifier and receiver.
• Connect the unit to a different mains circuit from that of the receiver.
• Consult your ROKSAN appointed dealer or an experienced Radio/TV technician for help and advice.
Location
Your Kandy K2BT Integtrated Amplifier should be located in a well ventilated area and kept away from sources of heat,
dust and humidity and from direct sunlight.
The integrated Amplifier may be positioned either as a free standing unit or along side another audio/video product.
Never allow liquids or other objects to fall into the unit.
This unit contains no user serviceable parts. DO NOT remove any panels or attempt to service it yourself.
Unauthorised servicing will void the warranty.
Roksan Audio Ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE
Kandy
Kandy K2 BT Integrated Amplifier User Manual
—2—
K2 BT Integrated Amplifier
Version 0.1
ENGLISH