Operation; Using The Controls; Mode Control - Roksan Audio K3 User Manual

Please refer to the front and rear panel views
The mains power switch (15) is located on the front under side of the
amplifier. This switch can be left ON for normal operation. If unattended for
a long period of time (going on a short break, holidays etc.) the mains
power should be switched OFF and the power cord disconnected from the
mains power input. When switched ON, your K3 integrated amplifier will be
on STANDBY with the MODE indicator (4) illuminated in GREEN. The
amplifier is now ready for use. Press the MODE button (1) on the front panel
once to activate your K3 Integrated Amp.
The amplifier will 'wake up', the MODE indicator illumination will change to
RED, the CD input will be selected and the CD input indicator (5) will
illuminate AMBER. The amplifier will then automatically check its input/
output status and after a brief moment when no problems are detected, the
speaker output relays will click on and the amplifier starts in normal
operation mode responding to all front panel buttons and the remote.
!
The MODE button on the Front Panel (1) has the following functions:
It activates the amplifier from Standby. NOTE: From the Remote Handset,
only the POWER Button (3) can put the amplifier in and out of standby.
Pressing the MODE button once with the amplifier activated will mute/lower
the volume level by 20dB. The MODE indicator light will change to AMBER.
The amplifier remains fully functional in this mode. Pressing MODE again
un-mutes the amplifier and the MODE indicator light will change to RED.
!
Page 11
!
!

Operation

Switching On
!

Using the Controls

Mode Control

!
!
!
!
!
Roksan Audio Ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE