Eu Directives; Ac Mains Supply; Connecting Mains Power - Roksan Audio Caspian Set Up Manual And Product Manual

E U D I R E C T I V E S
Roksan declares that the apparatus "Caspian Stereo Power Amplifier"
complies with the essential requirements and other relevant provisions of
Directive 1999/5/EC".
NOTE: This product must be earthed. Please ensure that other equipment
connected to it is earthed according to the manufacturer's instructions.
A C M A I N S S U P P L Y
Your Caspian Stereo Power Amplifier is set to operate from a fixed supply voltage which
is marked on a label next to the mains input socket. Before connecting the mains lead
please check that your mains supply corresponds to this list below:
230 V Products
115 V Products
100 V Products
The mains lead supplied with this product has an IEC C13 mains plug which is inserted
into the Mains Input Socket on the unit's rear panel. The other end is a moulded plug
appropriate to that for your country. In the UK this is the standard UK13A plug.
NOTE: Other international markets will require a different value plug and
protection fuses. Please contact us for more details.
This plug should ordinarily not be removed from the lead. If you do remove it,
please dispose of it safely so that it cannot be plugged into a mains socket whilst in
a potentially dangerous condition. If your lead has been damaged please obtain a
complete replacement lead from your dealer.
Should you move to another area where either the mains voltage or the mains plugs
are different from those as supplied with your amplifier, please contact the appointed
Roksan distributor for assistance.
Please observe correct mains polarity at all times.
The mains fuses are located on the rear panel below the IEC Mains Socket. These must
only be replaced by the fuse type and rating as described on the fuse rating label on the
rear panel of the unit.
If the equipment is likely to be unused for some time, unplug it from the mains supply.
C O N N E C T I N G M A I N S P O W E R
NOTE: The amplifier uses high current circuitry. Do not unplug the cable while
the amplifier is on.
The moulded IEC plug of the supplied mains lead should be plugged into the socket
on the rear of the unit first and then plugged into the mains supply. The Mains Power
Switch is on the left front underside of the amplifier. This switch can be left on; if
however the amplifier is likely to be unattended for a long period, switch it off and
unplug the mains lead from the wall.
2
Voltage Range: 220 – 240V
Voltage Range: 100 – 120V
Voltage Range: 90 – 110V
roksan.com