Advertisement
C A U T I O N
AC MAINS SUPPLY
Your M2 Integrated Amplifier is set to operate from a fixed supply voltage which is marked on a label next to
the mains input plug. Before connecting the mains lead please check that your mains supply corresponds to
this label as below:
230V Products
........................................
115V Products
........................................
100V Products
........................................
The mains lead supplied with this product has an IEC mains socket which plugs into the IEC connector on
the unit's rear panel. The other end is normally attached to the appropriate mains plug for your country. In
the UK this is the standard UK10A plug.
This plug should ordinarily not be removed from the lead. If you do remove it, please dispose of it safely so
that it cannot be plugged into a mains socket whilst in a potentially dangerous condition. We suggest that
you obtain from your dealer a complete replacement lead.
Should you move to another area where either the mains voltage or the mains plugs are different from those
as supplied with your Integrated Amplifier, please contact the appointed ROKSAN distributor for assistance.
Please observe correct mains polarity at all times.
The Integrated Amplifier mains fuses are located on the rear panel next to the IEC mains connector. These
must only be replaced by the fuse type and rating as described on the fuse rating label on the rear panel of
the unit.
If the equipment is likely to be unused for some time, unplug it from the mains supply.
GENERAL CAUTIONS
FCC WARNING
This equipment may generate or use Radio Frequency energy. The user may lose the right to operate this
equipment if unauthorised modifications are made.
INTERFERENCE
Properly installed, this unit should not cause harmful interference to radio communications, There is,
however, no guarantee that such interference will not occur in a specific installation. If interference arises
(which you can determine by switching the unit off and on) you could try to remedy this problem by the
following:
Re-orient or re-locate the receiving antenna
Increase the distance between the Integrated Amplifier and receiver
Connect the unit to a different mains circuit from that of the receiver
Consult your ROKSAN appointed dealer or an experienced Radio/TV technician for help and advice
LOCATION
Your M2 Integrated Amplifier should be located in a well ventilated area and kept away from sources of heat,
dust, humidity and direct sunlight.
The Integrated Amplifier may be positioned either as a free standing unit or alongside another audio/video
product. Never place the Integrated Amplifier on carpet or any surface likely to hinder normal ventilation.
Never allow liquids or other objects to fall into the unit.
This unit contains no user serviceable parts. DO NOT remove any panels or attempt to service it
yourself. Unauthorised servicing will void the warranty.
I N S TA L L AT I O N
Roksan M2 Integrated Amplifier - Front Panel View
1. Input Selector
2. Mode Button
3. Mode Indicator
4. CD Input Indicator
5. Tuner Input Indicator
6. Video Input Indicator
Caspian M2 Integrated Amplifier User Manual
3 4 5 6 7 8 9
12
1
2
M2 Integrated Amplifier
Voltage Range:
220V – 240V
Voltage Range:
100V – 120V
Voltage Range:
M2 Integrated Amplifier
10
7. Line 1 Input Indicator
8. Line 2 Input Indicator
9. Tape Monitor Indicator
10. Tape Monitor Button
11. Volume Control
12. AC Mains Switch
90V – 110V
11
Page 2
Advertisement
