Trainmaster Command Control Operations; Trainmaster Command Control Operations With Cab-1 Remote Controller; Operating Your Locomotive In The Command Control Environment - Lionel Big Boy Owner's Manual

TrainMaster Command Control operations

TrainMaster Command Control operations with CAB-1 Remote
Controller
T
o operate your locomotive in the TrainMaster Command Control environment, you need a
Command Base (available separately, 6-12911) and a CAB-1 Remote Controller (available
separately, 6-12868).
Your commands are sent by the CAB-1 Remote Controller to the Command Base, which
then translates the command into digital code. That code is sent through the outside rails
to your locomotive, which will not respond until it recognizes its unique ID#. TrainMaster
Command Control gives you the power to operate multiple Command-equipped locomotives
on the same track at the same time.
Keep in mind that track power is like gasoline in the tank of a car—it gives you the power
to go places, but it doesn't tell you where to go or how fast to get there.
Operating your locomotive in the TrainMaster Command Control
environment
1. Turn off track power and plug in the Command Base. Be sure that the
Command Base is connected to the outside rail or to the Common/Ground/U terminal on
your track power supply.
2. Place your locomotive on Lionel or Lionel-compatible O-72 or larger
track.
3. Increase track voltage to full power (no more than 19 volts AC). On
PowerMasters, slide the CMD/CONV switch to CMD. Program Track Power Controllers to
Command Control operation.
4. Press ENG and enter the ID# to address your locomotive with your CAB-1
Remote Controller. All Lionel locomotives come factory-programmed as ID# 1. To
change the ID#, see page 22.
5. Throttle up and move 'em out! Your locomotive will respond to every command from
your CAB-1 Remote Controller.
17