Like the TMCC Crane Car, the Boom Car was designed for use in the TrainMaster Note! Command Control environment only. For proper operation, be sure to assign the same ID# to the Boom Car and the Crane Note! Car. Table of contents...
Boom Car, you will need to use the TMCC Command Base (available separately, 6-12911) and a CAB-1 Remote Controller (available separately, 6-12868). 1. With track power off, place the Boom Car on the track. Be sure that the RUN/PROGRAM switch is in the RUN position. See Figure 1.
CAB-1 Remote Controller to activate the sounds and operate the crane. To silence the sounds, lift off the Boom Car’s roof and slide the SOUND switch to the NO SND position. Use the volume control knob located under the roof to adjust the volume. Refer to Figure 1 on page 3 for the location of these controls.
Page 5
CAB-1 Remote Controller commands for your Boom Car and Crane Car (continued) Lowers the small hook. Winch sounds. Raises the small hook. Winch sounds. Toggles the front work lights on and off. Switch sound. Toggles the rear work lights on and off. Switch sound.
3. Lift off the roof and slide the RUN/PROGRAM switch to the PGM position. Refer to Figure 1 on page 3. 4. Press ENG. 5. Enter the ID# for the Boom Car using the numeric keypad on the CAB-1 Remote Controller. Select any number between 1 and 99. Note! For proper operation, be sure to assign the same ID# to the Boom Car and the Crane Car.
(not included). Refer to Figure 2 for the location of the battery harness and clip. 1. Lift off the roof of the Boom Car. 2. Snap the battery harness onto the battery.
Page 8
(requires proof of purchase from the Lionel Authorized Retailer* it was originally purchased). Any products on which warranty service is sought must be sent freight or postage prepaid (Lionel will refuse any package when postage is due). Transportation and shipping charges are not covered as part of this warranty.
Need help?
Do you have a question about the Boom Car and is the answer not in the manual?
Questions and answers