Motor Primary Resistance; Calibration Parameters; Meter (Frequency Meter) Calibration (Japanese Version) - Mitsubishi FR - S500 Instruction Manual

2
.11.3

Motor primary resistance

Generally this parameter need not be set. At the factory setting of "- - -", the
standard motor constant of the motor capacity set in Pr. 98 (including that of the
constant-torque motor) is used.
Parameter Name
Motor primary
99
resistance
Related parameters
Applied motor setting
Automatic torque boost selection
2

.12 Calibration Parameters

2
.12.1 Meter (frequency meter) calibration
(Japanese version)
By using the control panel or parameter unit, you can calibrate a analog meter
connected to terminal FM to full scale deflection.
Terminal FM provides the pulse output. By setting the calibration parameter
C1, you can use the parameter to calibrate the analog meter connected to the
inverter without providing a calibration resistor.
Parameter Name
FM terminal
C1 (900)
calibration
The parameter number in parentheses applies to when the parameter unit (FR-PU04) is
used.
Factory
Setting
0 to 50 ,
- - -
Pr. 71 "applied motor" (refer to page 93)
Pr. 98 "automatic torque boost selection (motor capacity)"
(refer to page 109)
Factory Setting Setting Range
———
111
Setting
Range
Setting is enabled when Pr. 30 = "1"
- - -
Setting is enabled when
———
Pr. 30 = "1"
Remarks
Remarks
2