Table of Contents
Advertisement
Safety
This manual contains important safety and operation instructions for correct use of the power
supply. Read through the manual and pay special attention to the markings and labels of this unit
and equipment to be connected.
Pay special attention to these two types of notices used in this manual:
WARNING : Failure to observe this warning may cause injury to persons and damage to power
supply or connected equipment.
CAUTION : Failure to observe this warning may result in damage to equipment and
improper functioning of the power supply.
WARNING
1.
Do not use this power supply near water
2.
Do not operate or touch this power supply with wet hands
3.
Do not open the casing of the power supply when it is connected to ac mains
4.
Refer all servicing to qualified service personnel only
5.
Before replacing the AC fuse, determine the cause and clear up the cause first
6.
Replace the AC fuse with the same type and rating as the original fuse
7.
The maximum output voltage of the DCP60 exceeds 60VDC, avoid touching the metal
contact parts at the output terminals
CAUTION
1.
Use a grounded 3 pin AC source
2.
This unit is intended for indoor use only
3.
Do not operate or place this unit in a humid, dusty location
4.
Do not operate this unit in direct sunlight or near any heat source
5.
Before plugging into local AC mains, check with the rating label at the back of the unit
6.
Do not block any ventilation openings of the unit
7.
This unit must be used within the specified rating; regular excessive continuous loading may
cause damage to the power supply
8.
The gauge size of the input power cable must be at least 0.75mm
power cable must not exceed 3m
3
2
and the total length of
DCP60‐EU‐DE v1.4 9/13
Advertisement
Table of Contents
Need help?
Do you have a question about the DCP60 and is the answer not in the manual?
Questions and answers